Crochet bracelet explanation: Inserti

Four small inserts to sew one behind the other to personalize your crochet bracelet.
The explanation is adapted to the size of my wrist (about 17 cm).

Needed: cotton number 20 - crochet 1.0mm - scissors - needle - transparent plastic snap buttons.
At the ends of each bracelet sew the buttons.



Explanation of the dome insert

Start 4 chains and in the first make 9 double crochet (total 10), close the work and keep the cotton a little long, insert the needle and sew it to the bracelet with 3-4 stitches.


Explanation of the floret insert

Start 5 chains and close in a circle.
1st round: 2 chains, 2 double crochet, 2 chains, 1 slip stitch. Redo the same for a total of 5 small petals. Close the work by holding about 10 cm more cotton that will be used to sew the flower to the bracelet.
Prepare the small pistil to put in the center of the flower.

Start 4 chains and in the first make 2 double crochet, insert the crochet hook in the fourth chain (which replaces the first high point) and close the points together to obtain a small ball. Close the job by keeping the cotton a little long. Insert the small pistil inside the flower and sew it now in the lower part, then sew the flower to the bracelet.


Explanation of the star insert

Start 5 chains and close in a circle.
1st round: 2 low points, 1 half double crochet, 1 slip stitch in the first chain. Then 4 chains and redo 2 single crochet and 1 half double crochet again. Redo the same for a total of 5 times. Keep the cotton a little long before sewing to sew the insert to the cuff.

Explanation of the clamp insert

Start 21 chains and make 20 double crochet in these. Close the work by keeping the cotton a little long and sew the 2 ends together. Before inserting them in the cuff, turn them upside down, thus taking the natural shape a little rounded.

Have fun choosing the colors to match always following your imagination and inspiration of the moment. I hope I have explained everything to the fullest.
Good creation to all, hello.